- Little Witch: A little pumpkin witch from Jon Turner’s book Fragments, turned into a mini hard enamel pin. Specifications: Approx. 30mm tall. Rubber clutch to the reverse, and mounted to a special backing card.
- Binaries Are For Robots: Celebrate trans and non-binary pride and solidarity with this hard enamel pin badge.Specifications: Approx. 35mm across, with a double clutch to the reverse
- Wizard Ghost Wooden: A spooky little wizardy friend to add a bit of magic to your outfit. A little ghostie on a lovely sturdy wooden pin; the design, from Jon Turner’s original ink drawing, is printed onto sustainably sourced textured birch wood, and then lasercut. Specifications: Approx. 5cm tall. Pin back with a rubber clutch to the reverse, and presented on a spooky backing card.
- Simon the Clown Cat: Simply a cute little circus cat on a lovely sturdy wooden pin; the design is printed onto sustainably sourced textured birch wood, and then lasercut. Specifications: Approx. 5cm tall. Pin back with a rubber clutch to the reverse, and presented on a spooky backing card.
- The Owls Are Not What They Seem: A sturdy wooden pin badge; the original ink drawing design, inspired by Twin Peaks, is printed onto sustainably sourced textured birch wood, and then lasercut. Specifications: Approx. 5cm tall. Pin back with a rubber clutch to the reverse, and presented on a backing card.
- Patient Is The Night: A spooky little Over the Garden wall inspired sturdy wooden pin badge; the design, from the artist’s original ink drawing, is printed onto sustainably sourced textured birch wood, and then lasercut. Specifications: Approx. 5cm tall. Pin back with a rubber clutch to the reverse, and presented on a spooky backing card.
- Little Ghost enamel pin: A spooky friend on a hard enamel pin. 30mm tall (just over one inch). Rubber clutch to the reverse, and mounted to a ghostie backing card.
- Meadow ghost wooden pin: A little ghost in a field of flowers, on a lovely sturdy wooden pin; the design, from an original ink drawing by Jon Turner, is printed onto sustainably sourced textured maple wood, and then lasercut, with a pin back and rubber clutch to the reverse. Approximately 5cm (2 inches) tall. Presented on a backing card.
- Skull Cat wooden pin: A little cat who has found a cosy place to sit, on a lovely sturdy wooden pin; the design, from an original ink drawing by Jon Turner, is printed onto sustainably sourced textured maple wood, and then lasercut, with a pin back and rubber clutch to the reverse. Approximately 5cm (2 inches) tall. Presented on a spooky backing card.
Beoordelingen
Er zijn nog geen beoordelingen.